HP Designjet 250c Service Manual - Page 107
Reinstalling the Entry Platen, Inserting a screwdriver under
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Reinstalling the Entry Platen The order in which you replace the screws on the entry platen is important. 1 Position the entry platen between the two sideĆplates, feeding the media sensor cable under the right sideĆplate. 4 Refasten the indicated entryĆplaten clips. 2 Make sure that the mediaĆsensor cable is not obstructing the movement of the mediaĆsensor flags. 3 Slide the top of the entry platen in, and correctly position it on the inside of each sideĆplate. On each sideĆplate, the upper two pins should touch the entry platen above it. 5 Inserting a screwdriver under the sideĆplate on the right of the entry platen, lever the entry platen over to the left, so that it is flush against the left sideĆplate. C4699Ć90000 Removal and Replacement 6Ć49