HP Designjet 250c Service Manual - Page 184
DesignJet 330/350C Service Configuration Plot, Firmware Release: X.XX.XX, SPROC release: X.X
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
330 350C Service Configuration Plot for the DesignJet 330 and 350C The service configuration plot contains the following information: DesignJet 330/350C Service Configuration Plot Firmware Release: X.XX.XX SPROC release: X.X (Servo-Processor Code revision number.) EEROM Contents EEROM CONTENTS (This is for the plotter design engineers to interpret.) NOTE: All EEPROM Parameters are since last EEROM Reset. Number of Power Cycles: (Number of times plotter has been switched on.) Number of Color Plots: Number of Black Plots: Number of Pens: (Number of times each cartridge has been replaced. Cyan, Magenta, Yellow, Black.) Factory Spittoon: (The estimated level of ink in the spittoon. Incorrect if you have cleared the EEROM.) Number of Bail Errors: Number of System Errors: Last System Error: (To correctly interpret this information, refer to page 8-23.) Last System Error Data: (To correctly interpret this information, refer to page 8-23.) Bench Run: (Whether the bench run has been performed.) Bench Run Maximum Y-Axis (Carriage-Axis) PWM: (This should be less than 102. Typical value = 75.) Bench Run Maximum X-Axis (Media-Axis) PWM: (This should be less than 65. Typical value = 52.) Encoder-Tests Maximum Y-Axis (Carriage-Axis) PWM: (This should be less than 102. Typical value = 75.) Encoder-Tests Maximum X-Axis (Media-Axis) PWM: (This should be less than 65. Typical value = 52.) X-axis Calibration: 8Ć50 Troubleshooting C4699Ć90000