HP Designjet 250c Service Manual - Page 67
Removing the Left EndĆCover
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Removing the Left EndĆCover 1 Remove the top cover ' page 6Ć7. C 4 Pull the endĆcover up, and remove it from the plotter. 330 350C 2 Remove the rollĆfeed assembly ' page 6Ć8. 3 Release the three clips at the bottom of the endĆcover: first the side clip, then the front and back clips. These may be stiff. B C4699Ć90000 Reassembling: It's not easy to reinstall the endĆcovers on the plotter. With some practice, you should learn the knack. As a guide, before you replace an endĆcover, take a look at the various clips on its inside, and identify where A they fit on the plotter. Make sure that the primer plunger is installed properly when reinstalling the endĆcover. Removal and Replacement 6Ć9
330
350C
6Ć9
Removal and Replacement
C4699Ć90000
Removing the Left EndĆCover
1
Remove the top cover
'
page 6Ć7.
2
Remove the rollĆfeed assembly
'
page 6Ć8.
3
Release the three clips at the bottom of
the endĆcover: first the side clip, then the
front and back clips.
These may be stiff.
A
B
C
4
Pull the endĆcover up, and remove it from
the plotter.
Reassembling:
It's not easy to reinstall the
endĆcovers on the plotter. With some practice,
you should learn the knack. As a guide, before
you replace an endĆcover, take a look at the
various clips on its inside, and identify where
they fit on the plotter.
Make sure that the primer plunger is installed
properly when reinstalling the endĆcover.