HP Designjet 250c Service Manual - Page 175
Electrical Test, System Errors
View all HP Designjet 250c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
Electrical Test This tests the main PCA and carriage PCA electronics. 1 In service mode 2: 230 250C Hold down the SHIFT key and press Electrical Test. Electrical Test Shift 330 350C Press Electrical Test. Electrical Test The Load Media LED (or the Ready LED, if you have already loaded media) turns off for about 50 seconds while the plotter performs the electrical test. The shift key does not act as a stop-the-test key for this test. Status. If the test does not find an error, the Load Media LED (or the Ready LED, if you have already loaded media) turns on again. Otherwise, an error is reported by an error code on the front panel. The error code is usually shown as a ISteady 1238I (for DesignJet 230 and 250C) or a ISteady 1389I (for DesignJet 330 and 350C) which indicates a system error. See ' System Errors, page 8Ć19 (for DesignJet 230 and 250C) or page 8Ć23 (for DesignJet 330 and 350C), to be able to correctly troubleshoot the failure, and to be able to include the information when you exchange the electronics module. C4699Ć90000 Troubleshooting 8Ć41