HP Designjet 5000 HP Designjet 5000 series printer - User's Guide - Page 34
Onto the Take Up Reel, The Take Up Reel as an Accessory, Help with Loading, Move Media.
View all HP Designjet 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Introduction Media & Ink Solutions Front-Panel Printer Options Other Index Media Roll Media Sheet Media The Ink System The Ink Cartridge The Printhead The Printhead Cleaner Onto the Take Up Reel The Take Up Reel as an Accessory When loading media onto the Take Up Reel: Check the leading edge as it unwinds from the spool. If it is not evenly cut or if it is skewed, trim the media as shown in the animation. Check the media is straight when it is attached to the take up reel, otherwise the media will skew as it is wound onto the core. The core tube on the take-up reel must be the same width as the media you are using. Make sure the take-up core is pushed firmly into both media guides. If you need to feed more media from the printer and the "Move Media" screen is no longer displayed, go to the media menu and press Enter. Then select "Move Media". If you are using a three-inch cardboard core, make sure the core adaptors supplied with the printer, have been installed. See below. For the HP Designjet 60inch/1.57m printer the Take UP Reel is supplied as standard. For the HP Designjet 42inch/1.07m printer it is an optional accessory which you can order, see Ordering Accessories. Help with Loading When loading media there is information available from: The Pocket Guide installed at the back of the printer. The labels located on the printer and on the spindles. The front panel which will guide you through all the procedures step-by-step.