HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 100

Adaptec SCSI RAID Software Reference Guide Use the container list command after using the container extend volume command to display information about the volume set after you extend it, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size E: 1 Volume 164MB NTFS 2:02:0 200MB: 100MB 2:00:0 64.0KB: 32.0MB 2:01:0 64.0KB: 32.0MB The following list describes the change to the display as the result of extending a volume set with the container extend volume command: ■ The Total Size column displays a new size, taking into account the value(s) specified for the free_space parameters. In the example the new size is 164 MB. ■ The Usage column continues to display NTFS, indicating that array 1 has an NTFS file system on it. ■ The Scsi C:ID:L column displays the SCSI ID for the disk on which the original volume set was created. It also displays the SCSI ID(s) for the disk(s) from which you specified the freespace. In the example, these disks are 2:00:0 and 2:01:0. ■ The Partition Offset:Size column displays the partition offset(s) and size(s) for the partition(s) associated with the extended volume set. In the example the partition offsets and sizes are 64.0 KB and 32.0 MB. If a partition is dead, the ":" (colon) in the Partition Offset:Size column changes to a "!" (exclamation point). See the disk remove dead_partitions (page 7-9) command for more information on dead partitions. 5-52