HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 217

disk Commands disk show defects To show the number of defects and/or the defect list for a specific SCSI disk drive, use the disk show defects command. Syntax disk show defects [/full{=boolean}]{scsi_device} Parameters {scsi_device} Specifies the ID for the SCSI device for which you want to display defect information. A SCSI device consists of a SCSI channel number (for example, 0, 1, 2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI device logical unit number (0 through 7 inclusive). See the scsi_device section on page 3-7 for more information on how to specify the SCSI device. Switches /full{=boolean} Specifies whether to display the defect count and the list of disk defects. If you set this switch to TRUE, the command displays the list of defects and the number of defects. This switch defaults to FALSE, which means the command displays only the number of defects. Examples The following example lists the number of defects and the list of defects for a SCSI disk device (SCSI channel number 1, SCSI device ID 0, and SCSI logical unit number 0): AAC0> disk show defects /full=TRUE (1,0,0) Number of PRIMARY defects on drive: 2 Defect 1 at cylinder 12, head 5, sector 59 Defect 2 at cylinder 550, head 1, sector 44 Number of GROWN defects on drive: 0 7-17