HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 150
look for the disk that has enough space., command after using
View all HP Workstation xw6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Adaptec SCSI RAID Software Reference Guide As the following example shows, there is an array 0 (a mirror set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size D: 0 Mirror 10.0MB NTFS 0:02:0 64.0KB: 10.0MB 0:02:0 10.0MB: 10.0MB The following example assigns two SCSI failover disks to array 0. If you assign only one SCSI disk as a failover device, ensure that there is sufficient freespace. If you assign more than one SCSI disk as failover devices, you need ensure that only one of these disks has sufficient space. The reason for this is that the failover operation will look for the disk that has enough space. AAC0>container set failover 0 (0,3,0) (0,4,0) Executing: container set failover 0 (CHANNEL=0,ID=3,LUN=0) (CHANNEL=0,ID=4,LUN=0) Use the container show failover command after using the container set failover command to display information about the array just assigned failover disk(s). Related Information container commands: ■ container list (page 5-54) ■ container remove failover (page 5-86) ■ container show failover (page 5-116) 5-102