HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 81

container Commands Use the container list command after using the container create stripe command to display information about the stripe set, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Stripe 45.0MB 64KB None 0:02:0 64.0KB: 15.0MB 0:03:0 64.0KB: 15.0MB 0:04:0 64.0KB: 15.0MB The following list describes the items in the display that contain information as the result of creating a stripe set with the container create stripe command: ■ The Num Label column displays the ID number of the newly created stripe set, which in the example is 0. If you specify a label when creating the stripe set, it appears in this column. Because no label was specified when the stripe set was created, no label appears in the column. On UNIX systems, the root special file associated with the array also appears in this column. ■ The Type column displays the type Stripe, to indicate that the newly created array is a stripe set. ■ The Total Size column displays the size of the freespace that makes up the stripe set. In this example, the total size consists of the freespace (15.0 MB) specified with SCSI device (0,2,0) and equal sizes associated with SCSI devices (0,3,0), and (0,4,0) for a total of 45.0 MB. ■ The Stripe Size column displays the stripe size you specified for the stripe set. In this example, the stripe size is the default (32 KB). ■ The Usage column displays None to indicate that the newly created stripe set does not have a file system on it. To create an NTFS or FAT file system on an array, use the container format command. 5-33