HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 39

Syntax and Conventions for CLI Commands used is the first offset that starts a freespace area large enough to fit size bytes. Table 3-6 lists valid free_space specifiers. Table 3-6. Freespace Specifiers Freespace Specifier ((1,2),1G) 5 (8,2G) SCSI Channel Number, SCSI Device ID, SCSI Device LUN; Use n Amount of Freespace SCSI Device: Channel 1, Device ID 2, LUNdefault; use 1 GB of freespace SCSI Device: Channel default, Device ID 5, LUN default; use all freespace if empty or all of the first freespace available is some is used SCSI Device: Channel default, Device ID 8, LUN default; use 2 GB of freespace Note: When specifying freespace during an array create volume operation, you must explicitly specify the SCSI device's channel, device ID, and logical unit number. You cannot use any default values for the SCSI device. In addition, you must also specify the size of the freespace(s). container A controller currently supports 24 visible arrays. A visible array is an array that is visible to the operating system and users. Visible arrays are identified with array IDs 0 through 23. Array IDs 24 through 63 are reserved for hidden arrays. A hidden array is an array that is not visible to the operating system and can only be used by other arrays. (However, the array list command displays hidden arrays.) The Parameters section uses the following syntax to specify an array: {array} This syntax specifies the ID number (0 to 63 inclusive) of the array. A controller assigns a unique ID to each of its arrays when you create it. 3-9