HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 95

container Commands {container}... Specifies the ID number (0 to 63) of the array or arrays to add to the previously specified multilevel volume set. The previous file system information applies to these additional arrays as well. Examples Before extending a multilevel volume set, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a multilevel volume set) on this controller. In addition, the example shows array 1 and array 2 (both volume sets created with the container create volume command). AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 10MB NTFS 63 Volume 10MB 0:02:0 64.0KB: 10.0MB 1 Volume 15MB None 0:03:0 64.0KB: 15.0MB 2 Volume 15MB None 0:04:0 64.0KB: 15.0MB The following example extends a multilevel volume set (array 0) by adding arrays 1 and 2 (which are both volume sets): AAC0>container extend mvolume 0 1 2 Executing: container extend mvolume 0 1 2 container 0 extended As the command executes, note that the title bar of the DOS window displays the status of the command. For example: Stat:OK!Task:102,Func:FSX Ctr:0,State:RUN 84.3% See page 3-10 for detailed information on the status information that the command displays in the title bar as it executes the task. Use the container list command after using the container extend mvolume command to display information about the 5-47