HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 118
then no label appears in the column., promoting an array in this example, array 0 with
View all HP Workstation xw6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Adaptec SCSI RAID Software Reference Guide Examples Before promoting an array to a multilevel array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a stripe set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Stripe 45.0MB 32KB None 0:02:0 64.0KB: 15.0MB 0:03:0 64.0KB: 15.0MB 0:04:0 64.0KB: 15.0MB The following example promotes array 0 to a multilevel array: AAC0>container promote 0 Executing: container promote 0 Use the container list command after using the container promote command to display information about the array you just promoted, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Stripe 45.0MB 32KB None 63 Volume 15.0MB 0:02:0 64.0KB: 15.0MB 62 Volume 15.0MB 0:03:0 64.0KB: 15.0MB 61 Volume 15.0MB 0:04:0 64.0KB: 15.0MB The following list describes the change to the display as the result of promoting an array (in this example, array 0) with the container promote command: ■ The Num Label column displays four container IDs: 0 (the array that was promoted to a multilevel volume set), 63 (one of the underlying volume sets), 62 (a second underlying volume set), and 61 (a third underlying volume set). This column also displays the label assigned to the array when the array was created. If no label was assigned to the array then no label appears in the column. 5-70