HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 143

container Commands /wait{=boolean} Specifies whether the command performs the scrub action synchronously or asynchronously. If you set this switch to TRUE, the command performs the scrub action synchronously, which means the command prompt does not return until the scrub action completes. If you set this switch to FALSE, the command performs the scrub action asynchronously, which means the command prompt returns immediately. Examples Before scrubbing a redundant array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a mirror set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size D: 0 Mirror 10.0MB NTFS 0:02:0 64.0KB: 10.0MB 0:02:0 10.0MB: 10.0MB The following example synchronously scrubs array 0 using a delay time of 5 milliseconds: AAC0>container scrub /io_delay=5 /wait=TRUE 0 Executing: container scrub /io_delay=5 /wait=TRUE 0 As the command executes, note the title bar of the DOS window displays the status of the command. For example: Stat:OK!Task:100,Func:MSC Ctr:0,State:RUN 97.2% See page 3-10 for detailed information on the status information that the command displays in the title bar as it executes the task. 5-95