HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 64

Adaptec SCSI RAID Software Reference Guide Examples Before creating a multilevel stripe set, use the container list command to obtain information about any existing arrays. As the following example shows, there are two existing arrays (mirror sets) on this controller at the time the multilevel stripe set is created. These mirror sets were previously created with the container create mirror command. AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Mirror 15MB None 0:02:0 64.0KB: 15.0MB 0:02:0 15.0MB: 15.0MB 1 Mirror 15MB None 0:03:0 64.0KB: 15.0MB 0:03:0 15.0MB: 15.0MB The following example shows how to create a multilevel stripe set from two equally sized arrays, using the default stripe size of 64 KB. In this example, the two equally sized arrays are mirror sets: AAC0>container create mstripe 0 1 Executing: container create mstripe 0 1 container 0 created On UNIX systems, the message displayed after you execute the container create mstripe command includes the root special file associated with the newly created multilevel stripe set. Use the container list command after using the container create mstripe command to display information about the multilevel stripe set, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Stripe 30MB 0 64KB None 63 Mirror 15MB 0:02:0 64.0KB: 15.0MB 0:02:0 15.0MB: 15.0MB 62 Mirror 15MB 0:03:0 64.0KB: 15.0MB 0:03:0 15.0MB: 15.0MB 5-16