HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 294

Adaptec SCSI RAID Software Reference Guide enclosure show power To display the status of a specific power supply on a specific SAF-TE enclosure management device, use the enclosure show power command. You can also use this command to display the status of all power supplies on the enclosure management device or devices. Syntax enclosure show power [{enclosure}] [{powersupply}] Parameters {enclosure} Specifies the ID associated with the enclosure management device for which you want to display power supply status information. For this version, the controller supports a maximum of eight enclosure management devices on each bus. If you do not specify an ID, the command displays the power supply status for all enclosure management devices connected to the controller. {powersupply} Specifies the unit number associated with the power supply whose status you want to display. This integer can range from 0 to 15 inclusive. If you do not specify a unit number, the command displays the status for all power supplies on the enclosure management device or devices. Examples The following example displays the status of the power supplies on enclosure management devices 0 and 1: AAC0>enclosure show power Executing: enclosure show power Enclosure Power State Status 0 0 OK ON 1 0 OK OFF 11-30