HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 260
task stop
View all HP Workstation xw6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
Adaptec SCSI RAID Software Reference Guide task stop To stop one or all tasks running on the currently opened controller, use the task stop command. Syntax task stop [/all{=boolean}] Parameters {integer} Specifies the task ID for the task to stop. Perform a task list /all to display the task IDs for all tasks currently running on the open controller before stopping a specific task or all tasks. Switches /all{=boolean} Specifies whether to stop all running tasks. If you set this switch to TRUE, the command stops all tasks that were running on the currently opened controller. If you do not specify this switch or a valid task ID, the command displays an appropriate error message. Examples Before stopping a running task, use the task list command to identify any currently running tasks, as in the following example: AAC0>task list Executing: task list TaskId Function Done% Array 101 Scrub 24.6% 0 State ----RUN Specific1 --------00000000 Specific2 --------00000000 The following example shows the use of the task stop command to stop task 101: AAC0> task stop 101 Executing: task stop 101 Use the task list command after using the task stop command to display information about the task, as in the following example: 10-10