HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 55
State, Scsi C: ID: L, Partition Offset:Size, two halves of the mirror set.
View all HP Workstation xw6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
container Commands See page 3-10 for detailed information on the status information that the command displays in the title bar as it executes the task. Use the container list command after the container create mirror command completes execution to display information about the mirror set, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Mirror 10MB NTFS 0:02:0 64.0KB: 10.0MB 0:03:0 64.0KB: 10.0MB The following list describes the changes to the display as a result of using the container create mirror command: ■ The Type column displays a new array type, which in the example is Mirror instead of the previously displayed Volume. ■ The State column displays Normal (instead of a blank) as the mirror state. (Note that this column appears only if you specify the /full switch with the container list command.) ■ The Scsi C: ID: L column displays the SCSI device IDs for the two halves of the mirror set. ■ The Partition Offset:Size column displays the partition offset and size for the two halves of the mirror set. If a partition is dead, the ":" (colon) in the Partition Offset:Size column changes to a "!" (exclamation point). See the disk remove dead_partitions (page 7-9) command for more information on dead partitions. After creating a mirror set, you can manipulate it by using the ■ container split command to split a mirror set ■ container unmirror command to unmirror a mirror set 5-7