HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 120

Adaptec SCSI RAID Software Reference Guide container readonly To change an array's read-write status to read-only status, use the container readonly command. Subsequent modifications to the data on the array are prohibited. To use the container readonly command, the array cannot be in use by any application. Syntax container readonly {container} Parameters {container} Specifies the ID number (0 to 63) of the array to make readonly. Examples Before making an array read-only, use the container list command (with the /full switch) to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller. Note that the RO column is blank: AAC0>container list /full Executing: container list /full=TRUE 0 Num Total Oth Stripe Scsi Dr Label Type Size Ctr Size Usage C:ID:L F: 0 Volume 10.0MB NTFS 0:02:0 RO ---- Note that the example eliminates some items in the container list display so that you can see an example of the RO column. The following example changes array 0 from read-write status to read-only status: AAC0>container readonly 0 Executing: container readonly 0 5-72