HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 68

Adaptec SCSI RAID Software Reference Guide {container}... Specifies the ID (0 to 63) of one or more additional arrays from which you want to create the multilevel volume set. You can use up to 16 arrays. Typically, the additional arrays you specify are the same type as the first array. For example, if the first array is a stripe set then any subsequent arrays are also stripe sets. Switches /label{=string} Specifies a label to be assigned to the newly created multilevel volume set. You can specify a maximum of sixteen characters for the label. If you do not specify the switch, it defaults to no label. If you do not specify a label, you can do so later by using the container set label command. Examples Before creating a multilevel volume set, use the container list command to obtain information about any existing arrays. As the following example shows, there are two existing arrays (stripe sets) on this controller at the time the multilevel volume set is created: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Stripe 45MB 64KB None 0:02:0 64.0KB: 15.0MB 0:03:0 64.0KB: 15.0MB 0:04:0 64.0KB: 15.0MB 1 Stripe 15MB 64KB None 0:05:0 64.0KB: 15.0MB 5-20