HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 158

Adaptec SCSI RAID Software Reference Guide container show cache To display the current cache parameters associated with a specific array, use the container show cache command. Typically, you use this command after setting cache parameters for a specific array using the container set cache command. Syntax container show cache {container} Parameters {container} Specifies the ID number (0 to 63) of the array whose associated cache parameters you want to display. Examples Before setting cache parameters for a specific array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller with no file system on it (as evidenced by None displayed in the Usage column). Assume the cache parameters for this array were previously set with the container set cache command: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size 0 Volume 15.0MB None 0:02:0 64.0KB: 15.0MB 5-110