HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software Reference Guide - Page 116
Examples, Related Information, column displays ID number 5
View all HP Workstation xw6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
Adaptec SCSI RAID Software Reference Guide Examples Before renumbering an array, use the container list command to obtain information about any existing arrays. As the following example shows, there is an array 0 (a volume set) on this controller: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 0 Volume 20.0MB NTFS 0:02:0 64.0KB: 10.0MB 0:03:0 64.0KB: 10.0MB The following example renumbers array 0 to array 5: AAC0>container move 0 5 Executing: container move 0 5 Use the container list command after using the container move command to display information about the array you just renumbered, as in the following example: AAC0>container list Executing: container list Num Total Oth Stripe Scsi Partition Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size F: 5 Volume 20.0MB NTFS 0:02:0 64.0KB: 10.0MB 0:03:0 64.0KB: 10.0MB As a result of renumbering array 0 to array 5 with the container move command, the Num Label column displays ID number 5 instead of 0. This column also displays the label assigned to the array when the array was created. If no label was assigned to the array then no label appears in the column. Related Information container commands: ■ container list (page 5-54) 5-68