IBM TS2340 User Guide - Page 302

IBM Tape Diagnostic Tool a2500245 Figure 82. Encryption Start screen 5. If you entered the values correctly, press the Enter key to start the encryption. During the encryption, the program shows a progress indicator in form of a bar of hash marks (#) that shows the progress of a single sub-test as well as information about that sub-test. The Encryption function can be stopped by typing A followed by the Enter key at any time. Note: It may take some time until the Encryption function actually stops. If all encryption operations are finished, ITDT-SE shows a screen that displays the Status field on the bottom left side that indicates PASSED if the encrypted test completed successfully and ABORTED otherwise. The screen also shows the output files that were generated during the Encryption function: v file serial# .n.ENC contains the raw encrypted data v file serial# .n.DEC contains the decrypted data Table 30 defines the abort codes. Table 30. Definitions of Abort Codes ABORT CODE ROOT CAUSE LOCATE FAILED Start position as requested by the user could not be reached | MEDIUM NOT ENCRYPTED ITDT detected medium as non-encrypted NO DRIVER SPECIAL FILE System-Managed environment, but generic device file is used instead of IBM device driver special file DRIVE ENCRYPTION DISABLED Mode Sense detected disabled drive encryption UNEXPECTED DATA END OF MEDIUM v Set Raw read mode failed v One of the commands failed End of medium encountered before the given amount of data could be read 284 IBM Tape Device Drivers Installation and User's Guide