IBM TS2340 User Guide - Page 404

Linux - Tape Utility Program (IBMtapeutil) General Subcommands: tur reserve qryversion inquiry [Page] release logpage "Page" print "Text" reqsense modepage "Page" Tape Subcommands: bsf [Count] fsf [Count] fsfm [Count] compress nocompress load unload qrypos setpos [Blockid] offline rewoffl prevent allow qryinquiry bsr [Count] fsr [Count] bsfm [Count] tell rewind erase retension seod status parms list lock unlock qrysense eof [Count] weof [Count] asf [Count] seek [Count] sync display "Message" read -d Destination [-c Count] write -s Source rtest [-b Blocksize] [-c Count] [-r Repetition] wtest [-b Blocksize] [-c Count] [-r Repetition] rwtest [-b Blocksize] [-c Count] [-r Repetition] setblk [Count] density append mtdevice encryption Medium Changer Subcommands: allow inventory elementinfo devids prevent audit [Address [Count]] mount [Slot] position "Destination" unmount [Slot] move "Source" "Destination" exchange "Source" "Dest1" "Dest2" Service Aid Subcommands: dump [Filename] forcedump ucode "Name" resetdrive Figure 105. Linux Command Line Help Display General Subcommands The following general subcommands are available for the tape and medium changer devices. Items shown enclosed in square brackets, for example [Page], are optional. disablepath ″primary″ | number: The disablepath subcommand is used to disable a path to a medium changer. IBM recommends that you leave all paths enabled, but this subcommand can be used to disable a path. If ″primary″ is specified, the primary path is disabled. If a numeric value is specified, that specific path is disabled. Use the path command to obtain a list of the paths. If there is only one path available and you attempt to disable it, this subcommand fails with an illegal argument. If you attempt to disable a data path (to the tape drive), a ″function not implemented″ error is returned. This subcommand is only available in IBMtapeutil version 1.2.0 or higher, and the IBMtape device driver, version 1.4.1 or higher, on libraries that have the Control Path Failover feature enabled. enablepath ″primary″ | number: The enablepath subcommand is used to enable a path to a medium changer that has been previously disabled with the disablepath subcommand. If ″primary″ is specified, the primary path is enabled. If a numeric value is specified, that specific path is enabled. Use the path command to obtain a list of the paths. If you attempt to enable a data path (to a tape drive), a ″function not implemented″ error is returned. This subcommand is only available in IBMtapeutil version 1.2.0 or higher, and the lin_tape device driver, version 1.4.1 or higher, on libraries that have the Control Path Failover feature enabled. 386 IBM Tape Device Drivers Installation and User's Guide