IBM TS2340 User Guide - Page 393

HP-UX - Tape Utility Program (tapeutil) HP-UX System - Tape Utility Program (tapeutil) This chapter describes how to install, uninstall and use the IBM HP-UX Tape Utility Program, tapeutil. Command Sequence Information Take note of the following facts about the command sequences described in this section: v In some of the examples, filenames given on the command-line must be referenced with an absolute path. Using 'pwd'/filename to reference to a file instead of filename ensures this. v All the software distributor commands (for example, swinstall or swcopy) can first be run with the -p flag to preview the command. After observing the preview output, reissue the command without the -p flag to perform the actual operation. v The software distributor commands are moderately complex scripts that frequently require several steps. The steps are typically Selection, Analysis, and Execution. Each step may produce useful information and error messages, so it is a good idea to carefully observe the results of the installation process as it occurs. If you run into unexpected results during the installation, check the associated log file. Product Requirements The following hardware and software components are required and supported by IBM and are necessary for implementation of the tapeutil. Tapeutil Implementation The tapeutil program contains utility program implementations for operation in the following HP-UX platform environments: v HP Precision Bus - HP-UX 10.20 and 11.00 - versions of this program are identified by levels tapeutil.hpux.3.x.x.x v HP PCI Bus - If you are using the ATDD version 1.7.7.2 or later, on HP-UX 11.00, use tapeutil.hpux.4.0.0.0 or later. If you are using the ATDD version 3.0.0.1 or later, on HP-UX 11i, use tapeutil.hpux.4.0.0.0 or later. Otherwise, use tapeutil level tapeutil.hpux.3.x.x.x. Hardware Requirements Refer to "Hardware Requirements" on page 56. Install tapeutil Installing the product manually requires the three steps detailed in the following sections: 1. "Copy the Software to the Software Depot" on page 375 2. "Review the tapeutil README File" on page 376 3. "Install tapeutil" on page 376 Copy the Software to the Software Depot Copy the software from its location to the Software Depot. # swcopy -p -s /tapeutil_location/tapeutil.hpux.x.x.x.x tapeutil (preview option) # swcopy -s /tapeutil_location/tapeutil.hpux.x.x.x.x tapeutil Appendix D. Tape Utility Programs 375