IBM TS2340 User Guide - Page 371
Windows - Verifying Proper Attachment of Your Devices, Return to continue, Enter
UPC - 883436006873
View all IBM TS2340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 371 highlights
Windows - Verifying Proper Attachment of Your Devices When the Return to continue: message is displayed or when you are told to enter information, press Enter after following the instruction. When the utility displays information, use the appropriate hardware manual to verify that the information is reasonable. 1. Open a Windows NT command shell window. 2. Enter ntutil. 3. Select 1 (Manual test). 4. Enter 50 (poll registered devices). All devices detected by adapters (that were attached and powered-On at system start time) should be displayed. You should see lb1.0.0.1 in the list of found devices. 5. Enter 8 (Library Mode). 6. Enter 20 (open). 7. Enter 1 (Read/Write). 8. Enter 49 (inquiry). Reply with 0 (zero) to the Drive=0, Library=1 prompt. This step concludes a very basic test of the device, adapter connection, and the device driver. You may stop the test here or continue to perform a more complete test. 9. Enter 39 (test unit ready) until no error occurs. Each time you are prompted with a Drive=0, Library=1 prompt, reply with 1 (zero). 10. Enter 12 (ioctl initialize element status). 11. Enter 10 (ioctl return library inventory). 12. From the output in the previous step, select a writable, scratch cartridge and determine its element ID. Also, select the element ID of an unoccupied slot. 13. Enter 11 (ioctl move medium), then supply the address of the cartridge and the address of the unoccupied slot. Verify that the cartridge moved. 14. Enter 10 (ioctl return library inventory). Verify that the inventory was updated properly. 15. Enter 21 (close). 16. Enter 99 (return to main menu). 17. Enter 9 (Exit ntutil). Note: See Microsoft Windows System for information on the ntutil application. 3494 Enterprise Tape Library Attachment Test The following procedure tests the attachment of a 3494 Enterprise Tape Library to a Windows system. The procedure assumes that your device is defined in c:\winnt\ibmatl.conf as L3494. 1. Open a Windows command shell window. 2. Enter mtlib -l L3494 -qI 3. Enter mtlib -l L3494 -qL Appendix B. Verifying Proper Attachment of Your Devices 353