IBM TS2340 User Guide - Page 324

IBM Tape Diagnostic Tool | setparm | (Deprecated: -o spa / volid / compress / nocompress / sili / nosili / autoload / | noautoload / retain / noretain) | ITDT-SE will use the new setparm option that corresponds to the current | interactive mode options. | Parameters: The Value will be | v 0-65535 for the blocksize parameter | v 0-100 for the capacity parameter (=percentage) | v 1 (SCSI) and 2 (AIX) for recordspacemode | v the Volume Id string for the volid parameter | v NONE|ASSO|PERS|WORM for the writeprotect parameter | v 0 for off/no and 1 for on/yes for setparm autoload, autodump, buffering, | compression, immediate, readpastfilemark, sili, simmim, trace, trailer, | volumelogging | Supported platforms: All, but only a subset of the parameters is supported by the | platform's device drivers: | Table 31. Supported Platforms | Linux Windows AIX Solaris HP-UX | setparm autoload X | setparm autodump X | setparm blocksize X X X X X | setparm buffering X X X X | setparm capacity X X X X | setparm compression X X X X X | setparm immediate X X X X | setparm readpastfilemark X | setparm recordspacemode X | setparm sili X X X | setparm simmim X | setparm trace X | setparm trailer X X X X | setparm volid X | setparm volumelogging X X | setparm writeprotect X X X X | | setpos | (Deprecated: -o spo / asf) This subcommand issues the SCSI Locate command to | the device to set the tape position. If the optional Blockid parameter is specified, | the tape position is set to the Blockid. Otherwise, if the Blockid parameter is | omitted, the tape position is set to the last position saved using the qrypos | subcommand. | Parameters: 306 IBM Tape Device Drivers Installation and User's Guide