IBM TS2340 User Guide - Page 394

HP-UX - Tape Utility Program (tapeutil) Use swlist to verify that the tapeutil software is in the depot: # swlist -d tapeutil Review the tapeutil README File After copying the tapeutil software to the depot, use the swlist command to view the README file in the directory /opt/tapeutil: # swlist -d -a readme tapeutil The README file lists the system configuration requirements, including required system software patches and required tape related firmware versions. The file also documents any changes in the installation, use, and administration of the software that occurred after this documentation was completed. Review it before proceeding with the software installation. Install tapeutil When the software is in the depot, the tapeutil software can be installed to the root file system using the HP-UX swinstall command. The following commands install tapeutil from the depot to the default root file system: # swinstall -p tapeutil (preview option) # swinstall tapeutil You can use swlist to list the software installed on the default root file system as follows: # swlist tapeutil You can verify correct installation to the default root file system with the swverify command: # swverify tapeutil Uninstalling tapeutil Attention: Do not try to uninstall the ATDD software by simply deleting the files that make up the ATDD fileset. This causes a number of inconsistencies on the system. It is best to use the swremove command. To remove the tapeutil software from the root file system, enter: # swremove -p tapeutil (preview option) # swremove tapeutil Other Administrative Tasks To determine the version of tapeutil currently installed on the default root file system: # swlist -a state tapeutil To determine the version of tapeutil stored in the default depot: 376 IBM Tape Device Drivers Installation and User's Guide