IBM TS2340 User Guide - Page 368
Solaris System, Tape Device Attachment Test, Solaris - Verifying Proper Attachment of Your Devices
UPC - 883436006873
View all IBM TS2340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 368 highlights
Solaris - Verifying Proper Attachment of Your Devices Solaris System Tape Device Attachment Test The following procedure tests the attachment of a tape device to a Sun Solaris system. The procedure assumes that your device is attached at /dev/rmt/0st. When you are told to enter information, press Enter after following the instruction. When the utility displays information, use the appropriate hardware manual to verify that the information is reasonable. 1. Bring up a shell prompt. 2. Enter tapeutil. A menu is displayed. 3. Enter 1 (Open a Device). 4. Enter /dev/rmt/0st when prompted for the device name. 5. Enter 1 (Read/Write). 6. Enter D (Device Info). 7. Enter 10 (Inquiry). 8. Enter Q to quit tapeutil. Autochanger Device Attachment Test The following procedure tests the attachment of an autochanger device to a Sun Solaris system. The procedure assumes that your device is attached at /dev/rmt/0smc and that the ACF is in Random mode. You also need a cartridge in at least one of the slots. When you are told to enter information, press Enter after following the instruction. When the utility displays information, use the appropriate hardware manual to verify that the information is reasonable. 1. Bring up a shell prompt. 2. Enter tapeutil. A menu is displayed. 3. Enter 1 (Open a device). 4. Enter /dev/rmt/0smc when prompted for the device name. 5. Enter 1 (Read/Write). 6. Enter D (Device Info). 7. Enter 5 (Inquiry). This concludes a very basic test of the device, SCSI connection, and the device driver. You may stop the test here or continue to perform a more complete test. 8. Enter 6 (Test Unit Ready) until no error occurs. 9. Enter 17 (Element Inventory). 10. From the output in the previous step, select a writable, scratch cartridge and determine its element ID. Also, select the element ID of an unoccupied slot. 11. Enter 14 (Move Medium), then supply the address of the cartridge and the address of the unoccupied slot. Verify that the cartridge moved. 12. Enter 17 (Element Inventory). 13. Verify that the inventory was updated properly. 14. Enter 2 (Close a Device). 15. Enter Q (Quit Program). 350 IBM Tape Device Drivers Installation and User's Guide