IBM TS2340 User Guide - Page 335

IBM Tape Diagnostic Tool | a2500265 | | Figure 90. Toolbar Buttons | v Click the Scan menu item in the Control Center to display the list of tape devices found. When the scan is complete, select one device in the Test Lab by clicking the corresponding checkbox. v Test Click the arrow next to the Test menu item to select an extended test. v Dump Click the arrow next to the Dump menu item to select additional log options. v Update Click the Update menu item to start the firmware update. For each device on which the operation has been started, a tab appears on the right panel (Test Lab area). The tab contains the operation information and status. Only one operation can be run at a time with ITDT-GE. The benefit in using tabs even for the single operation mode is that you get a history of operations as for each consecutive operation, a separate tab is opened. Graphical Edition - Scan Menu Commands The following commands are described in this section: v "Scan" on page 318 v "Test" on page 319 v "Dump" on page 321 v "Firmware Update" on page 322 v "Encryption" on page 323 v "Full Write" on page 324 v "Tape Usage" on page 326 v "System Test" on page 326 v "Library Diagnostic Self-Test" on page 327 Chapter 10. IBM Tape Diagnostic Tool (ITDT) 317