Icom IC-7700 Instruction Manual - Page 138

9 SCANS ■ Programmed scan operation [SQL] PROG F-1 EXIT/SET Main dial q Push EXIT/SET several times to close a multi-function screen, if necessary. w Select VFO mode. e Select the desired operating mode. • The operating mode can also be changed while scanning. r Push [SCAN] F-5 to select the scan screen. t Set [SQL] open or closed. • See page 9-2 for squelch condition. y Push [PROG] F-1 to start the programmed scan. • " PROGRAM SCAN " and decimal points blink while scanning. u When the scan detects a signal, scan stops, pauses or ignores it depending on the resume setting and the squelch status. i To cancel the scan, push [PROG] F-1 . • Rotating the main dial also cancels the scan. o Push and hold [RECALL] F-6 for 1 sec. to recall the frequency that is set before starting the scan, if desired. If the same frequencies are programmed into the scan edge memory channel P1 and P2, programmed scan will not start. ■ ∂F scan operation [SQL] ∂F ∂F SCAN EXIT/SET Main dial F-2 F-4 q Push EXIT/SET several times to close a multi-func- tion screen, if necessary. w Select VFO mode or a memory channel. e Select the desired operating mode. • The operating mode can also be changed while scan- ning. r Push [SCAN] F-5 to select the scan screen. t Set the main band's [SQL] open or closed. • See page 9-2 for squelch condition. y Set the ∂F span by pushing [∂F SPAN] F-4 . • ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz, ±500 kHz and ±1000 kHz are selectable. u Set center frequency of the ∂F span. i Push [∂F] F-2 to start the ∂F scan. • " :F SCAN " and decimal points blink while scanning. oWhen the scan detects a signal, the scan stops, pauses or ignores it depending on the resume set- ting and the squelch status. !0 To cancel the scan, push [∂F] F-2 . • Rotating the main dial also cancels the scan. !1 Push and hold [RECALL] F-6 for 1 sec. to recall the frequency that was set before starting the scan. 9-4