Icom IC-7700 Instruction Manual - Page 187
All Clear
View all Icom IC-7700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
■ Fuse replacement MAINTENANCE 13 When no external DC output is available from [EXT DC] and ACC connectors, the internal fuse may be open. Replace the fuse in this case. WARNING: DISCONNECT the AC power cable from the AC outlet before removing the transceiver's cover. q Remove the bottom cover as shown left. w Remove the 8 screws from the shield cover of the transceiver's bottom side. e Replace the open fuse with a new, properly rated one (FGB 2 A) as shown at left. r Return the inside cover and bottom cover and screws to the original position. ■ Resetting the CPU POWER MW F-IMP ENT q Turn the main power switch on the rear panel ON. • Make sure the transceiver power is still OFF. w While pushing and holding F-INPENT and MW , push POWER to turn power ON. • The internal CPU is reset. • The CPU start-up takes approx. 5 sec. • The transceiver displays its initial VFO frequencies when resetting is complete. e Correct the set mode settings after resetting, if desired. NOTE: Resetting CLEARS all programmed contents in memory channels and returns programmed values in set mode to default values. ALL CLEAR 13-7