Icom IC-7700 Instruction Manual - Page 18

1 PANEL DESCRIPTION ■ Front panel (continued) $3 $4 $5 $6 $7 $8 $9 %0 %1 %2 NSCEIVER 7700 MONITOR D DELAY NB NB RF DRIVE TX RX SPLIT LOCK 1.8 1 10 4 21 7 GENE 3.5 2 14 5 24 8 50 0 MP-W MW 7 3 18 6 28 9 F-INP ENT MP-R V/M XFC A/B A=B TS F-1 F-2 SSB CW COMP MONI GAIN F-3 RTTY/PSK F-4 AM/FM F-5 DATA VOX GAIN ANTI VOX CONTRAST F-6 M.SCOPE F-7 EXIT/SET BRIGHT REC PLAY VOICE MEMORY AUTO TUNE LOCK FILTER PBT-CLR TWIN-PBT DIGI-SEL DIGI-SEL NOTCH APF/TPF NOTCH RIT/∂TX RIT ∂TX CLEAR SPEECH CW PITCH SPLIT %3 %4 %5 %6 %7 %8 %9 ^0 $3 MODE SWITCHES Selects the desired mode. (p. 3-8) • Announces selected mode via the speech synthesizer. (p. 12-15) SSB Selects USB and LSB modes alternately. CW Selects CW and CW-R (CW reverse) modes alternately. RTTY/PSK ➥ Switches between RTTY and PSK mode. ➥ Switches RTTY and RTTY-R (RTTY reverse) mode when pushed and held for 1 sec. in RTTY mode. ➥ Switches PSK and PSK-R (PSK reverse) mode when pushed and held for 1 sec. in PSK mode. AM/FM Selects AM and FM modes alternately. DATA ➥ Selects SSB, AM or FM data mode (USB-D, LSB-D, AM-D, FM-D) when pushed in SSB, AM or FM mode, respectively. ➥ Switches D1, D2 and D3 when pushed and held for 1 sec. $4 QUICK TUNING SWITCH [TS] ➥ Turns the quick tuning step ON and OFF. (p. 3-6) • While the quick tuning indicator, "Z," is displayed above the frequency indication, the frequency can be changed in programmed kHz steps. • 0.1, 1, 5, 9, 10, 12.5, 20 and 25 kHz steps are available for each operating mode independently. ➥ When the quick tuning step is OFF, push and hold for 1 sec. to turn the 1 Hz tuning step ON and OFF. (p. 3-7) ➥ When the quick tuning step is ON, push and hold for 1 sec. to enter quick tuning step set mode. (p. 3-6) $5 VFO SELECT SWITCH A/B Switches the selected VFO between the VFO-A and VFO-B when pushed. • Switches between transmit frequency and receive frequency when the split frequency function is ON. (p. 6-6) $6 MEMORY WRITE SWITCH MW (p. 8-3) Stores the selected readout frequency and operating mode into the displayed memory channel when pushed and held for 1 sec. • This function is available both in VFO and memory modes. 1-8