Kenwood TS-990S Operation Manual - Page 193

MEMORY CHANNELS 10 CONFIGURING THE OPERATING DATA TO A DUALBAND MEMORY CHANNEL You can configure operating data such as the frequency, operating mode and operating status (split frequency, dual-band receive frequencies, transmit frequency during split operation) for use with a split operation or dual-band reception Memory Channel. 1 Configure the frequency, operating mode, and operating status (split operation, dual frequency reception, TF watch) to the main band and sub band. 2 Press [M.IN] (Memory) to open the Memory Channel List screen. 3 Press [ ] (F2) or [ ] (F3), or rotate the MULTI/CH control to select the Memory Channel (00 to 99 or E0 to E9) to configure the operating data. CONFIGURING OPERATING DATA BY DIRECTLY ENTERING A FREQUENCY You can configure a frequency for Memory Channels or change existing Memory Channel operating data using the numeric and band select keypad. This is useful when tuning the frequency to a station with a fixed frequency. /VNFSJD
BOE
#BOETFMFDU
,FZQBE 3> 4 Press [D-M.IN] (F6) to configure the operating data. • The operating data is configured for the main band in Frequency 1, for the sub band in Frequency 2 and the operating status is configured for TX/RX Func for the Memory Channels selected at step 3, and then the Memory Channel List screen closes. • Press [CANCEL] (F1) or [ESC] to close the Memory Channel List screen without configuring operating data to a Memory Channel. Note: ◆◆Operating data cannot be configured for a Dual-band Memory Channel in the following cases: • When a Memory Channel with no operating data configured in the main band or sub band is used • When the single-band reception is selected during simplex operation ("RX" and "TX" in the sub band displays are both grayed out) Contents Index 1 Press [M/V] to enter single-band Memory Channel mode or press and hold [M/V] to enter dual-band Memory Channel mode. 2 Rotate the MULTI/CH control to select the Memory Channel (00 to 99 or E0 to E9) to configure the operating data. 3 Press [ENT] to enable the use of numeric keys. • Press to turn the backlight for the numeric keypad ON. • Frequency entry mode is activated for the target band and the numbers in the frequency display are all replaced with "-" (dash). • Press the mode key to change the operating mode. 4 Press the numeric keys to enter a frequency. • Enter a number with the numeric key, and the dashes are replaced by the entered number, starting with the uppermost digit. To enter 1.82 MHz, press [0/50], [1/1.8], [8/24], and [2/3.5] and then press [ENT] to complete the entry. • Press [CLR] to clear the entered number, and the frequency entry ends. 5 Press [ENT] to configure the operating data. The operating data is configured for the Memory Channel selected at step 2. Note: ◆◆If a frequency is entered directly in a Memory Channel with no operating data configured, the frequency is configured as the operating data of the single-band Memory Channel. ◆◆To enter main band and sub band frequencies in a dual-band Memory Channel, press and hold [M>V] to enter dual-band Memory Channel mode. Enter the frequency to the main band and then to the sub band. 10-3