Kenwood TS-990S Operation Manual - Page 260
Configuring The I/o Signals For The Acc 2 Connector, Configuring The Input Audio Level
![]() |
View all Kenwood TS-990S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
16 USEFUL FUNCTIONS CONFIGURING THE I/O SIGNALS FOR THE ACC 2 CONNECTOR If you connect an external device to the ACC 2 connector on the rear panel, you can configure the audio signal input level. CONFIGURING THE INPUT AUDIO LEVEL You can configure the audio signal input level from the ACC 2 connector on the rear panel. 1 Select Group No. 7, "Rear Connectors", from the Menu screen. 2 Access Menu 06, "ACC 2: Audio Input Level". 3 Press [SELECT] (F4) to allow editing of the parameter box. 4 Press [-] (F4) and [+] (F5), or rotate MULTI/CH control to select the input level from the available range between "0" and "100". The default is "50". 5 Press [ ] (F1). 6 Press [MENU] to exit. CONFIGURING THE OUTPUT AUDIO LEVEL If you connect an external device to the ACC 2 connector on the rear panel, you can configure the audio signal output levels of the main band and sub band independently. 1 Select Group No. 7, "Rear Connectors", from the Menu screen. 2 Access Menu 10, "ACC 2: Audio Output Level (Main Band)" or Menu 11, "ACC 2: Audio Output Level (Sub Band)". 3 Press [SELECT] (F4) to allow editing of the parameter box. 4 Press [-] (F4) and [+] (F5), or rotate the MULTI/CH control to select the audio signal output level for the main band from the available range between "0" and "100". The default is "50". 5 Press [ ] (F1). 6 Press [MENU] to exit. Selecting the Audio Output Format FROM THE ACC 2 Connector You can select the output format of the received audio sent from the ACC 2 connector on the rear panel. With the default configuration, the received audio of the main band is sent from the MANO terminal, and the received audio of the sub band is sent from the SANO terminal. 1 Select Group No. 7, "Rear Connectors", from the Menu screen. 2 Access Menu 17, "ACC 2: Audio Output Configuration". 3 Press [SELECT] (F4) to allow editing of the parameter box. 4 Press [-] (F4) or [+] (F5), or rotate the MULTI/CH control to select "Normal", "Reversed", or "Mixed". The default is "Normal". 5 Press [ ] (F1). 6 Press [MENU] to exit. Note: ◆◆Output audios vary depending on the parameter as follows. Parameter MANO Terminal SANO Terminal Normal Reversed Mixed Received audio of the main band Received audio of the sub band Mixed audio of the receive signals of the main band and the sub band Received audio of the sub band Received audio of the main band Mixed audio of the receive signals of the main band and the sub band 16-20 Index Contents
![](/manual_guide/products/kenwood-ts990s-operation-manual-3ab92e4/260.png)