Kenwood TS-990S Operation Manual - Page 205

11 SCAN 3 Press [ ] (F2) or [ for Group Scan. ] (F3) to select a Group 4 Press [ ] (F4), or rotate the MULTI/CH control to specify whether or not the transceiver scans the Memory Channels in the grouped Memory Channels. • Each key press toggles a tick mark on (allows scanning) or off (does not allow scanning). • To start All Channel Scan, place a tick mark on all memory groups. • Pressing [SEL.ALL] (F6) selects and places a tick mark on all Memory Channels. • Pressing [CLR.ALL] (F6) deselects and removes the tick mark from all Memory Channels. 5 Press [ESC] to exit. Note: ◆◆If the Memory Group to be scanned has been configured as below, Memory Scan does not start even with the press of [SCAN] (F5). • T ick marks on all Memory Groups are removed (deselected). • Even if a tick mark is placed on a Memory Group, no operating data is stored on the Memory Channels in this Memory Group. • Even if a tick mark is placed on a Memory Group, all Memory Channels in this Memory Group are locked out. ◆◆The Memory Channels in the Memory Groups are listed below. Combinations of the Group number and Memory Channel numbers. Group Memory Channel Group Memory Channel 0 00 to 09 6 60 to 69 1 10 to 19 7 70 to 79 2 20 to 29 8 80 to 99 3 30 to 39 9 90 to 99 4 40 to 49 P P0 to P9 5 50 to 59 E E0 to E9 ◆◆Examples of Configurations for All Channel Scan and Group Scan • If you place tick marks on Memory Groups 1 and 5, pressing [SCAN] (F5) starts the Group Scan. The Memory Channels in Memory Groups 1 and 5 will be scanned. • If you place tick marks on all Memory Groups, pressing [SCAN] (F5) starts All Channel Scan. ◆◆Even if a tick mark is placed for a Memory Channel (the scan is enabled), the transceiver does not scan the Memory Channel to which no operating data is stored for the Memory Channel in a Memory Group or the Memory channel is locked out. If the transceiver starts scanning while in Dual Memory Channel mode, the transceiver does not scan Program Memory Channels P0 to P9. LOCKING OUT A MEMORY CHANNEL You can select Memory Channels to be exempted from Memory Scan. 1 Press [M.LIST] (F7) to open the Memory Channel List screen. 2 Press [ ] (F2) or [ ] (F3), or rotate the MULTI/CH control to select a Memory Channel. 3 Press [L.OUT] (F6) to lock out a Memory Channel. • A tick mark is placed on the section of "L.OUT" of the selected Memory Channel. • If [L.OUT] (F6) is unavailable in the function key guide, press [MORE] (F1). • Pressing [L.OUT] (F6) again disables the Lockout for the Memory Channel. 4 Press [ESC] to exit. Contents Index 11-5