Kenwood TS-990S Operation Manual - Page 294
Product Specifications - dimensions
View all Kenwood TS-990S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 294 highlights
19 MISCELLANEOUS PRODUCT SPECIFICATIONS General Frequency range (Transmitter) 160m band 80m band 60m band *5 Frequency range (Receiver) *1 40m band 30m band 20m band 17m band 15m band 12m band 10m band 6m band Mode Frequency stability Antenna impedance Antenna tuner load range Power supply voltage Power At transmit (maximum) consumption At receive (no signal) Usable temperature range Dimensions Without projection Include projection At front leg up position Weight Transmitter Output power CW/SSB/FSK/PSK/FM (AM) Modulation Maximum frequency deviation (FM) Spurious emissions Carrier suppression Unwanted sideband suppression Transmit frequency response Microphone impedance XIT variable range 1.8 ~ 2.0 MHz (K-type), 1.81 ~ 2.0 MHz (E-type) 3.5 ~ 4.0 MHz (K-type), 3.5 ~ 3.8 MHz (E-type) 5.1675, 5.25 ~ 5.45 MHz (K-type), 5.25 ~ 5.45 MHz (E- type) 7.0 ~ 7.3 MHz (K-type), 7.0 ~ 7.2 MHz (E-type) 10.1 ~ 10.15 MHz 14.0 ~ 14.35 MHz 18.068 ~ 18.168 MHz 21.0 ~ 21.45 MHz 24.89 ~ 24.99 MHz 28.0 ~ 29.7 MHz 50.0 ~ 54.0 MHz (K-type), 50.0 ~ 52.0 MHz (E-type) 0.13 ~ 30 MHz, 50 ~ 54 MHz VFO: Continuous 30 kHz ~ 60 MHz A1A (CW), A3E (AM), J3E (SSB), F3E (FM), F1B (FSK), G1B (PSK) Within ±0.1 ppm, 0°C ~ +50°C (32°F~122°F) 50 Ω 16.7Ω ~ 150Ω AC 120 V ±10 % (60 Hz) (K-type) AC 220-240 V ±10 % (50/60 Hz) (E-type) *2 720 VA or less (K-type), 840 VA or less (E-type) 120 VA or less (K-type), 200 VA or less (E-type) 0℃ ~ +50℃ (32°F~122°F) W460 x H165 x D400 mm (W18.11 x H6.50 x D15.75 in) W460 x H182 x D449 mm (W18.11 x H7.17 x D17.68 in) front panel: H201 mm (H7.91 in), rear panel: H173 mm (H6.81 in) Approx. 24.5 kg (54.01 lbs) 200 W (50 W) SSB: Balanced, AM: Low Power, FM: Reactance wide: ±5 kHz or less, narrow: ±2.5 kHz or less HF (Harmonics): -60 dB or less HF (others): -50 dB or less 50 MHz: -66 dB or less -60 dB or less -60 dB or less Within -6 dB (300 ~ 2700 Hz) 600 Ω ±9.999 kHz Receiver Circuit type Intermediate frequency Sensitivity (Typcal) 1st IF 2nd IF (FM) 3rd IF (FM) SSB, CW, FSK, PSK (S/N 10 dB) AM (S/N 10 dB) FM (12 dB SINAD) Image Rejection Ratio (50 MHz) Main Double Sub1 *3 Double superheterodyne superheterodyne 8.248 MHz 11.374 MHz 24 kHz/ (455 kHz) 24 kHz - - 0.5 μV (0.13 ~ 0.522 MHz) 4 μV (0.522 ~ 1.705 MHz) 0.2 μV (1.705 ~ 24.5 MHz) 0.13 μV (24.5 ~ 30 MHz) 0.13 μV (50 ~ 54 MHz) 6.3 μV (0.13 ~ 0.522 MHz) 32 μV (0.522 ~ 1.705 MHz) 2 μV (1.705 ~ 24.5 MHz) 1.3 μV (24.5 ~ 30 MHz) 1.3 μV (50 ~ 54 MHz) 0.22 μV (28 ~ 30 MHz) 0.22 μV (50 ~ 54 MHz) 70 dB (60 dB) or more Sub2 *4 Triple superheterodyne 73.095 MHz 10.695 MHz 24 kHz/ (455 kHz) IF Rejection Ratio Selectivity SSB (LO: 200/ HI: 2800 Hz) CW, FSK, PSK (WIDTH: 500 Hz) 70 dB or more 2.4 kHz or more (-6 dB) 4.4 kHz or less (-60 dB) 500 Hz or more (-6 dB) 1.2 kHz or less (-60 dB) AM (LO: 100/ HI: 3000 Hz) FM XIT variable range Notch filter attenuation Beat cancel attenuation Audio output Audio output impedance 6.0 kHz or more (-6 dB) 12 kHz or less (-50 dB) 12 kHz or more (-6 dB) 25 kHz or less (-50 dB) ±9.999 kHz 60 dB or more (Auto), 70 dB or more (Manual) 40 dB or more 1.5 W or more (8Ω) 8Ω *1 MAIN BAND: Spec. guaranteed in amateur band 160m through 6m *2 The AC power cable supplied with the product is only suitable for AC 120V (K-type) or AC 220V-240V (E-type). *3 In 160m/80m/40m/20m/15m Amateur bands, IF bandwidth 2.7 kHz or less (SSB, CW, FSK, PSK) *4 Except in above *3 *5 60m band: Refer to applicable Amateur Radio regulations for your country. Internal beat may occur during amateur radio band reception depending on combination of main band and sub band Spurious signals other than the reception signal may also appear on the bandscope (waterfall view). Note: ◆◆Measured values are subject to the measuring method stipulated by Japan Amateur Radio Industries Association. ◆◆Specifications are subject to change due to technical developments. 19-2 Index Contents