Kenwood TS-990S Operation Manual - Page 195
Selecting A Memory Channel, Directly Entering The Memory Channel Number
View all Kenwood TS-990S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
MEMORY CHANNELS 10 SELECTING A MEMORY CHANNEL The Memory Channel selected for the main band and the sub band can be switched individually. 1 Press [] to select a sub band Memory Channel. 2 Press [UP] (microphone) or [DOWN] (microphone), or rotate the MULTI/CH control to select a Memory Channel. TEMPORARILY CHANGING THE OPERATING DATA While using operating data configured in a Memory Channel, you can temporarily change the frequency and other operating data without changing the operating data. .PEFLFZT 5VOJOH . Note: ◆◆In Dual-band Memory Channel mode, the Memory Channels of both bands are switched simultaneously with whichever band is selected. TEMPORARILY CHANGING THE FREQUENCY Change the configuration as follows to temporarily change the frequency. 1 Select Group No. 4, "Memory Channels & Scan", from the Menu screen. 2 Access Menu 01, "Temporary Change (Memory Channel Configurations)". DIRECTLY ENTERING THE MEMORY CHANNEL NUMBER The channel number for a single-band Memory Channel or dual-band Memory Channel can be selected using the numeric and band select keypad. 1 Press [] to select a band. 2 Enter the number of the tenths digit for the Memory Channel with a numeric key. The number is displayed to the tenths digit for the Memory Channel number of the selected band, and "-" (dash) is displayed for the units digit. 3 Enter the number of the units digit for the Memory Channel with a numeric keypad. • The operating data for the corresponding channel number is diverted and channel number entry ends. • Press [CLR] to cancel entry and the Memory Channel number entry ends. Note: ◆◆In Dual-band Memory Channel mode, when the operating data is diverted for a band, the unselected band also receives the data from the same channel number. ◆◆While a Quick Memory Channel is in use, the number of the Quick Memory Channel cannot be configured. 3 Press [SELECT] (F4) to allow editing of the parameter box. 4 Press [-] (F4) or [+] (F5) to select "On". The default is "Off". 5 Press [ ] (F1). 6 Press [MENU] to exit. 7 Press [M/V] to enter single-band Memory Channel mode or press and hold [M/V] to enter dual-band Memory Channel mode. 8 Rotate the Tuning (M) control to change the frequency. To configure the changed frequency, configure it to a different Memory Channel. {page 10-2} {page 10-3} Note: ◆◆For Program Memory Channels, the operating data configured in the Memory Channel is updated when the frequency or mode is changed regardless of this configuration. ◆◆The operating data related to the operating mode and FM tone can be temporarily changed regardless of this configuration. Contents Index 10-5