Kenwood TS-990S Operation Manual - Page 75

BASIC OPERATIONS 4 ANALOG METER RESPONSE SPEED You can configure the response speed of the needle on the analog meter. 1 Select Group No. 0, "Basic Configurations", from the Menu screen. 2 Access Menu 09, "Meter Response Speed". 3 Press [SELECT] (F4) to allow editing of the parameter box. S-meter for the sub band appears on the upper right side of the main display. S-meter for the sub band Note: ◆◆If an analog meter is connected to the METER terminal on the rear panel, the signal level can be observed on both the front panel and the external meter. {page 16-15} ◆◆COMP meter can be selected while the Speech Processor is active. METER PEAK-VALUE HOLD Indicates the held peak-value in the digital meter. 1 Select Group No. 0, "Basic Configurations", from the Menu screen. 2 Access Menu 11, "Meter Display Peak Hold". 3 Press [SELECT] (F4) to allow editing of the parameter box. 4 Press [-] (F4) or [+] (F5) to select one from "1" to "4". The default is "3". 5 Press [ ] (F1). 6 Press [MENU] to exit. Note: ◆◆The configured parameter also applies for the vertical meter used in SWL mode. 4 Press [-] (F4) or [+] (F5) to select "Off" or "On". The default is "On" (use with Meter Peak Hold). Selecting "Off" disables the Meter Peak Hold. In this case, the peak values remain displayed for the duration below. Upper Display: 0.5 seconds Middle and Lower displays: 0.3 seconds (except SWR meter) 5 Press [ ] (F1). 6 Press [MENU] to exit. Contents Index 4-21