Kenwood TS-990S Operation Manual - Page 206

11 SCAN QUICK MEMORY SCAN Quick Memory Scan enables the transceiver to change the configured Quick Memory Channels at certain time intervals, to scan. 1 Press [MR] (Quick Memory) to read a Quick Memory Channel. RESUMING THE SCANNING Scan stops if the transceiver receives a signal during the Program Scan (VFO Scan) while in FM mode or during Memory Scan or Quick Memory Scan regardless of the operating data. The conditions to resume scanning after scanning stops can be configured. Time-operated: Scan stops for three seconds upon receipt of a signal. If the reception continues even after three seconds, scan stops for the three seconds once a signal is received and continues even after three seconds, and again after three seconds. After this, the transceiver resumes scanning even if the transceiver continues receiving. (In other words, the maximum scan stop time while in Time-operated mode is six seconds.) Carrier-operated: Scan stops while the transceiver receives a signal. The transceiver resumes scanning two seconds after there is no longer a signal. 1 Select Group No. 4, "Memory Channels & Scan", from the Menu screen. 2 Access Menu 05, "Scan Resume". 3 Press [SELECT] (F4) to allow editing of the parameter box. 2 Press [SCAN] (F6) to start Quick Memory Scan. • Rotating the MULTI/CH control fast-forwards or fastreverse the scanning sequence. • Pressing [SCAN] (F5) again or pressing [ESC] stops Quick Memory Scan. Note: ◆◆If the transceiver starts the reception in the main band or sub band, scan stops. ◆◆The scan time for each frequency during Quick Memory Scan is 400 ms. However, if the transceiver receives a CTCSS tone while in FM mode, the scan time for each frequency is extended to 600 ms. ◆◆During Quick Memory Scan, "SCANNING" appears in place of the scan speed. 4 Press [-] (F4) or [+] (F5) to select either "Carrieroperated" or "Time-operated". The default is "Time-operated". 5 Press [ ] (F1). 6 Press [MENU] to exit. 11-6 Index Contents