Kenwood TS-990S Operation Manual - Page 194

10 MEMORY CHANNELS MEMORY CHANNEL MODE There are two Memory Channel modes allowing you to use the operating data configured for Memory Channels: Single-band Memory Channel mode and Dual-band Memory Channel mode.You can transmit and receive with operating data diverted from Memory Channels.You can temporarily change the operating data such as the transmit and receive frequencies, operating mode and tones. OPERATING IN SINGLE-BAND MEMORY CHANNEL MODE You can divert the operating data of a Memory Channel configured in the main band or the sub band. The operating data for the Memory Channel configured for "Frequency 1" in the Memory Channel List is diverted. 1 Press [M/V] while in VFO mode to enter Single-band Memory Channel mode. The selected band is switched to the operating data set for Frequency 1 in the Memory Channel List and the corresponding memory channel number appears on the main screen. OPERATING IN DUAL-BAND MEMORY CHANNEL MODE The same Memory Channel can be diverted to the main band and sub band at the same time, and the operating status, such as split operation, dual frequency reception, and TF watch, can be stored to a Memory Channel. You can divert the operating data of the Memory Channels configured for the main band and the sub band. The operating data for the Memory Channel configured with "Frequency 1", "Frequency 2", and "TX/RX Func." in the Memory Channel List is diverted. 1 Press and hold [M/V] while in VFO mode to enter Dualband Memory Channel mode. The operating data is switched to those configured in "Frequency 1", "Frequency 2", and "TX/RX Func." in the Memory Channel List for the main band and the sub band, and the corresponding Memory Channel number appears on the main screen reversing the outlined letter to white or black. 2 Press [M/V] again to exit Single-band Memory Channel mode. The transceiver diverts to VFO mode. 2 Press [M/V] again to exit Dual-band Memory Channel mode. The transceiver diverts to VFO mode. 10-4 Index Contents