Kenwood TS-990S Operation Manual - Page 244

16 USEFUL FUNCTIONS RESET The configuration data stored in the transceiver can easily be saved in other memory devices. Additionally, to delete the operating data stored in the transceiver memory and to store new operating data, you can select the intended reset from five reset types. • Menu Reset: Resets all parameters on the Menu screen to their defaults. • Memory Channel Reset: Resets the configuration data for the memory channels and quick memory channels. • VFO Reset: Resets all operating data in the VFO. • Standard Reset: Resets all operating data except the configuration data for the Clock, Transmit Power Limiter, and TX Inhibit. • Full Reset: Resets all configuration data in the transceiver to their defaults. Note: ◆◆The configuration data for memory channels, quick memory channels, all data on the menu, preset values for the antenna tuner, auto-mode frequency data, and various levels will not be reset. ◆◆Once any reset begins, the data will be cleared. Reset the transceiver after the configuration data has been stored in another storage device. ◆◆In Menu 1-06, the default for Automatic Voice Guidance is "Off". Activating any reset other than Memory Channel Reset and VFO Reset will reset Menu 1-06 to their default; hence, the transceiver does not do any voice guidance by Automatic Voice Guidance. {page 14-2} ' 3 Press [SELECT] (F4). • A message prompting the start of the reset appears. • Pressing [CANCEL] (F4) does not start the resetting process and closes the message that prompted you to start the resetting process. 4 Press [RESET] (F4). The transceiver is reset and automatically restarts. SELECTING THE OPERATING BAND FOR THE HI/SHIFT LO/WIDTH CONTROLS Using the HI/SHIFT LO/WIDTH control, you can adjust the cutoff frequencies (low and high) and the passband width and shift. You can configure whether to adjust the main band or both the main band and the sub band. 1 Select Group No. 0, "Basic Configurations", from the Menu screen. 2 Access Menu 14, "Operating Band (High/ Low & Shift/ Width Controls)". 3 Press [SELECT] (F4) to allow editing of the parameter box. Follow the procedure below to reset the transceiver. 1 Press [RESET] (F) on the Menu screen to open the Reset screen. 2 Press [ ] (F2) or [ ] (F3), or rotate the MULTI/CH control to select a reset type. Press [MENU TOP] (F) to close the Reset Configuration Data screen and display the Menu screen. 4 Press [-] (F4) or [+] (F5) to select "Main and sub bands" or "Main Band only". The default is "Main and sub bands". 5 Press [ ] (F1). 6 Press [MENU] to exit. Note: ◆◆If "Main Band only" is selected, the "SUB" LED on the right of the HI/SHIFT LO/WIDTH controls does not light. In this case, rotating the HI/SHIFT LO/WIDTH controls increases or decreases the value for the HI/SHIFT and LO/WIDTH. 16-4 Index Contents