Konica Minolta AccurioPress C14000 Plockmatic PowerSquare R2L User Manual - Page 116
Change the Fuses - Side-Trimmer
View all Konica Minolta AccurioPress C14000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
5 - Troubleshooting - Change the Fuses - Side-Trimmer Change the Fuses - Side-Trimmer Introduction The Side-Trimmer has two fuses at the power input connector. See "The SideTrimmer" on page 8.. If either fuse is broken, the Side-Trimmer will not operate. Warning: Electrical Shock Hazard Turn OFF the machine and remove the mains power supply cable before you change the fuses. This machine uses two fuses in parallel. Warning: Electrical Fire Hazard Always replace a fuse with one that is of the same type and that has the same rating. An incorrect fuse can cause a fire. Fuse Description • 7A, HRC Quick acting, F • Part Number 4-730-018 Procedure 1. Turn OFF the Side-Trimmer. 2. Disconnect the Side-Trimmer from the power supply. 3. Check each fuse. 4. If the fuse is broken then replace with a fuse of the correct specification. Result If the fuse breaks again, then call your Plockmatic service engineer. 110 Plockmatic PowerSquare™224 User Manual