Netgear WN203 User Manual - Page 4
Management, Advanced Configuration, Monitoring, Troubleshooting - bridge
View all Netgear WN203 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ProSAFE Single Band 802.11n Wireless Access Point WN203 Schedule the Wireless Radios to Be Turned Off 49 Configure Basic Wireless Quality of Service 49 Chapter 4 Management Enable Remote Management 52 SNMP Management 52 Secure Shell and Telnet Management 53 Upgrade the Wireless Access Point Software 54 Web Browser Upgrade Procedure 55 TFTP Server Upgrade Procedure 56 Manage the Configuration File or Reset to Factory Default 57 Save the Configuration 57 Restore the Configuration 58 Restore the Wireless Access Point to the Factory Default Settings . . . . 58 Reboot the Wireless Access Point without Restoring the Default Configuration 60 Change the Administrator Password 61 Enable the Syslog Option 62 Enable Rogue AP Detection and Monitor Access Points 62 Enable and Configure Rogue AP Detection 63 View and Save Access Point Lists 64 Chapter 5 Advanced Configuration Configure Spanning Tree Protocol and 802.1Q VLANs 68 Configure Hotspot Settings 69 Configure Advanced Wireless Settings 70 Configure Advanced Quality of Service Settings 73 Configure Wireless Bridging 75 Configure a Point-to-Point Wireless Network 76 Configure a Point-to-Multipoint Wireless Network 81 Configure the Wireless Access Point to Repeat the Wireless Signal Using Point-to-Multipoint Bridge Mode 85 Chapter 6 Monitoring View System Information 92 Monitor Wireless Clients 94 View the Activity Log 96 Traffic Statistics 97 Chapter 7 Troubleshooting Basic Functioning 100 Verify the Correct Sequence of Events at Startup 100 No LEDs Are Lit on the Wireless Access Point 100 LAN LED Is Not Lit 101 WLAN LED Is Not Lit 101 You Cannot Access the Internet or the LAN from a 4