Netgear WN203 User Manual - Page 86
Wireless Point to Multi-Point Bridge
View all Netgear WN203 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
ProSAFE Single Band 802.11n Wireless Access Point WN203 Internet AP1 Router Multipoint bridge mode repeating only LAN segment 1 AP2 Multipoint bridge mode repeating only AP3 Multipoint bridge mode repeating only Hub or switch LAN segment 2 Figure 18. Repeating the wireless signal in point-to-multipoint bridge mode To configure the wireless access point to repeat the wireless signal: 1. Configure the security profiles on the wireless access point (AP2 on LAN Segment 2 in the previous figure): a. Select Configuration > Wireless Bridge. The Bridging screen displays (see the following figure). b. Select the Enable Wireless Bridging check box. The Local MAC Address field is a nonconfigurable field that shows the MAC address of the wireless access point. c. Select the Wireless Point to Multi-Point Bridge radio button. The screen adjusts. The profile table shows four security profiles. Advanced Configuration 86