Panasonic AG-HPX600PJ Operating Instructions - Page 20
Power supply and accessory mounting
View all Panasonic AG-HPX600PJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Chapter 2 Description of Parts - Power supply and accessory mounting section Power supply and accessory mounting section 9 10 8 11 12 13 2 3 14 4 1 56 7 1 switch (page 35) Used to turn on/off the power. 2 Battery release lever (page 90) Pull this battery release lever down to release the battery. 3 Battery holder (page 90) Mount the Anton/Bauer battery. 4 Light control switch (page 90) 5 terminal (page 91) This is the input terminal for the external power supply. Connect to the external DC power supply. 6 (DC power supply) output terminal (page 101) This is the DC 12 V output terminal. It provides a maximum current of 1.5 A. @@NOTE tt When connecting external equipment to this terminal, first fully check the polarities of the connection. Failure to do so may result in a malfunction. 7 terminal (page 152) (page 151) Connect the remote control unit AJ‑RC10G (optional) to remotecontrol some functions. Connect the extension control unit AG‑EC4G (optional) to remotecontrol some functions. 8 Light output terminal Connect the Anton/Bauer Ultralight 2 (optional) or an equivalent product of 50 W or under for the video light. The battery charge level drops sharply when the light is illuminated. When using the light, using a battery of 90 Wh or more is recommended. 9 Cable holders Used for clamping the light and microphone cables in place. 10 Accessory mounting holes Attach accessories. Do not use for purposes other than attaching accessories. ffMounting hole size -- 1/4‑20 UNC (screw length 10 mm or shorter) -- 3/8‑16 UNC (screw length 10 mm or shorter) 11 Shoulder strap fittings (page 99) Attach the shoulder strap. 12 Light shoe Attach the video light. ffMounting hole size 1/4‑20 UNC (screw length 6 mm or shorter) 15 16 17 18 19 20 13 Viewfinder left/right positioning ring To adjust the left/right position of the viewfinder, loosen this ring, and slide the viewfinder to the left or right to adjust it to an easy-toview position. Tighten the ring to clamp the viewfinder in place after adjusting the viewfinder. 14 terminal Mount the viewfinder AG‑CVF10G (optional). 15 Lens cable/microphone cable clamp (page 93) This clamp secures the lens and microphone cables. 16 terminal (page 93) Connect the lens connection cable. For a detailed description of the lens used, refer to the Operating Instructions for the lens. 17 Tripod mount (page 99) Attach the optional tripod adaptor (SHAN-TM700) when mounting the camera on the tripod. 18 Lens mount (2/3-type bayonet) (page 93) Mount the lens. 19 Lens lever (page 93) After mounting the lens to the lens mount, tighten the lever to secure the lens. 20 Mount cap (page 93) Raise the lens lever to remove the cap. Replace the cap when the lens is not mounted. - 20 -