Pioneer AVIC-Z110BT Owner's Manual - Page 182
Appendix - gps antenna
UPC - 012562956404
View all Pioneer AVIC-Z110BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
Appendix Appendix Symptom Cause Action (Reference) You cannot position your vehicle Something covers the GPS antenna. Do not cover the GPS antenna with spray on the map without a significant paint or vehicle wax, because this may block positioning error. the reception of GPS signals. Snow buildup can also degrade the signals. Signals from the vehicle's speed Check that the cables are properly connected. pulse are not being picked up prop- If necessary, consult the dealer that installed erly. the system. The navigation system may not be mounted securely in your vehicle. Check that the navigation system is securely mounted and, if necessary, consult the dealer that installed the system. The navigation system is installed with an extreme angle exceeding the installation angle limitations. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to Installation Manual.) Indication of the position of your vehicle is misaligned after a U-turn or reversing. Check whether or not the reverse gear signal input lead (violet) is connected properly. (The navigation system works properly without the lead connected, but positioning accuracy will be adversely affected.) The map color does not switch automatically between daytime and nighttime. [Day/Night Display] is set to [Day]. Check "Day/Night Display" setting and make sure "Automatic" is selected. (Page 48) The orange/white lead is not connected. Check the connection. The screen is too bright. An improper value has been set on Check the settings. (Page 160) "Brightness". The display is very dim. The vehicle's light is turned ON, and Read about [Day/Night Display] setting and, [Automatic] is selected on [Day/ if desired, select [Day]. (Page 48) Night Display]. An improper value has been set on Check the settings. (Page 160) "Brightness". No sounds of AV source are pro- The volume level is low. duced. The volume level will not rise. The attenuator or mute is on. A speaker lead is disconnected. Adjust the volume level. Turn the attenuator or mute off. Check the connection. The volume of navigation gui- VOL (+/-) button is used to adjust dance and beeps cannot be ad- the volume. justed. Turn the volume up or down using [Volume] on the "System Settings" menu. (Page 100) The person on the other end of the phone call cannot hear the conversation due to an echo. The voice from the person on the Use the following methods to reduce the other end of the phone call is output echo: from the speakers and then picked -Lower the volume on the receiver up by the microphone again, creat- -Have both parties pause slightly before ing an echo. speaking There's no picture. The parking brake cord is not con- Connect the parking brake cord, and apply nected. the parking brake. The parking brake is not applied. Connect the parking brake cord, and apply the parking brake. The backlight of the LCD panel is turned off. Turn on the backlight. (Page 104) 182 En