Sharp MX-C300W Operating Guide - Page 156
MISFEED IN THE MACHINE, Misfeed in the paper feed area
![]() |
View all Sharp MX-C300W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
TROUBLESHOOTING MISFEED IN THE MACHINE To remove a misfeed from inside the machine, open the side cover, check whether the misfeed occurred in "A", "B", or "C" below, and follow the misfeed removal procedure. 1 Open the bypass tray and the side cover. Note If paper remains in the bypass tray, remove the paper. 2 Check the misfeed location. Remove the misfed paper following the instructions for each location in the illustration below. Area B If the misfed paper is visible here, go to "Misfeed in the fusing area B" (p.157). Area C If paper is misfed here, go to "Misfeed in the transport area C" (p.158). Area A If paper is misfed here, go to "Misfeed in the paper feed area A" (p.156). Misfeed in the paper feed area A 1 Carefully remove the misfed paper. Turn the roller rotating knob in the direction of the arrow to assist in removing it. Roller rotating knob Fusing unit Be careful not to tear the misfed paper during removal. The fusing unit is hot. Do not touch the fusing Warning unit when removing misfed paper. Doing so may cause a burn or injury. When removing misfed paper, do not touch or damage Caution the transfer belt. 2 Close the side cover. The message " Clear paper path." will be cleared and copying will be possible. Note • When closing the side cover, press on around the handle. • If the message does not clear, check again to make sure that no pieces of paper remain. 156
![](/manual_guide/products/sharp-mxc250-operating-guide-d437d13/156.png)