Sharp MX-C300W Operating Guide - Page 181

SYSTEM SETTINGS Enter Auto Power Shut-Off after the Remote Job This function works in Auto Power Shut-Off mode. When the machine completes a print job received from the PC or outputs received fax data, the machine immediately returns to the Auto Power Shut-Off mode. Toner Save Mode (Copy) Toner Save Mode (Print) You can reduce the amount of toner used for copying/printing. Note Toner Save Mode (Print) is only effective when the machine's printer driver is not used. When the printer driver is used, the printer driver setting takes precedence. This function may not operate in some applications and operating systems. List Print This is used to print lists and reports that are only for use by the administrator of the machine. Select the [List Print] to configure the settings. Fax Settings Shows the current state of the system settings, as well as the sender name, sender number, polling passcode numbers, and forwarding numbers. Inbound Routing Shows the inbound routing settings for routing received faxes on your network. User Usage List Shows the communication time and number of pages transmitted by each user. Activity Report Shows a log of past communication performed on the machine (date of communication, name of other party, time required, result, etc.). Junk Fax # List Shows the stored fax numbers from which reception in "Anti Junk Fax" (p.188) is blocked. User Info. Print The user name, user number, paper used, paper limits, and function permission settings can be printed for each user. *Cannot be printed if no users are registered. AutoColorCalib. This is used to perform automatic color correction when the color in color copies is off. The machine prints a test patch, the test patch is scanned, and the color is automatically corrected. After the [OK] is selected and a test patch is printed, a message appears prompting you to begin automatic calibration. Place the test patch on the document glass as shown below (so that the light patch at the edge of the page is to the left). Align the upper left corner of the original with the mark. Align the upper left corner of the original with the mark. Lay copy paper (about five sheets) that is the same size as the test patch on top of the placed test patch, gently close the automatic document feeder, and select the [OK]. Note • Before executing Auto Color Calibration, check to see if the registration adjustment is correct. If the registration adjustment is not correct, perform "Registration Adjustment" (p.179). • If the color is still off after performing Auto Color Calibration, repeating Auto Color Calibration once again may improve the color. 181