Sharp MX-C300W Operating Guide - Page 179
Device Control, Operation Setting, Fusing Control, Fusing Cleaning, Registration Adjustment
View all Sharp MX-C300W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
SYSTEM SETTINGS Device Control These settings are used to configure settings for hardware functions of the machine. To access one of these settings, select "Device Control" in the mode selection screen, select the desired setting in the device control screen, and press the [OK] key. Operation Setting These settings are used to configure various settings related to the operation panel. To access one of these programs, select "Operation Setting" in the mode selection screen, select the desired setting in the operation setting screen, and press the [OK] key. Fusing Control The temperature of toner fusing is controlled according to the weight of the paper that is used. Note • Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix in other standard paper that differs from the set range. • When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see "POWER ON AND OFF" (p.15). Fusing Cleaning Use this function to clean the machine's fusing unit when dots or other dirt appear on the printed side of the paper. When this function is executed, "V" printed paper is output and the fusing unit is cleaned. Note If improvement is not noticed after the first time you use the function, try executing the function again. Registration Adjustment If the colors are out of place on the printed surface when color printing is performed, the print positions of the colors can be adjusted. Select "Registration Adj." and press [OK] key to start automatic registration. When appearing the complete message, the adjustment is completed. Note Depending on the machine's condition, adjustment error message may appear. In that case, execute the registration adjustment again. Auto Clear This function returns the copy settings to the default settings if the operation panel is not used for the duration of time set with this setting following the end of a copy job. Time selections are "0 sec.", "10 sec.", "20 sec.", "60 sec.", "90 sec." and "120 sec.". The factory default setting is 60 seconds. Select "Auto Clear" and press the [OK] key. The following screen will appear. Select the desired time with the [ ] or [ ] key. If you do not want auto clear to operate, select "0". Note The Auto Clear function is disabled when scanned data is stored under the following status: When the last page has not been scanned during the 2 IN 1 or 4 IN 1 copy process (one page has been scanned for a two-page set or three pages have been scanned in a four-page set), or only one side has been scanned in the ID card copy process. Disable Display Timeout This setting is used to select whether or not the display will automatically return to the base screen if no keys are pressed on the operation panel for one minute in scan or fax mode. The factory default setting is automatic return to the base screen. Language Setting This setting is used to select the display language. Select "Language Setting", press the [OK] key, and follow the steps below. Message Time This setting is used to set the length of time that messages appear in the display (this applies to messages that appear for a certain length of time and then automatically disappear.) Select from "Short (3 sec.)", "Normal (6 sec.)", or "Long (9 sec.)". The factory default setting is "Normal (6 sec.)". 179