Brother International Entrepreneur PR-650 Users Manual - English - Page 121

Note ● Depending on the pattern density and fabric used, there may be shrinking of the pattern or the appliqué may be misaligned with the placement line. We recommend cutting slightly outside of the cutting line. ● When using patterns that are vertically and horizontally symmetrical, use a chalk pencil to indicate the pattern orientation before cutting it out. ● Carefully cut out the pattern on the outline you just sewed. Do not cut inside the cutting line, otherwise the appliqué fabric will not be caught by the appliqué stitch. Use two layers of adhesive water-soluble 0 stabilizer material with their sticky sides together, and then hoop them in the embroidery frame. Lightly apply glue or spray adhesive, and b paste the appliqué piece so that it aligns with the placement line. Note ● Before pasting the appliqué piece down, make sure the appliqué piece is positioned correctly within the placement line. Sew the outline "APPLIQUE". c 4 Note ● If water-soluble stabilizer is used, it is not necessary to remove the stabilizer material after sewing the appliqué outline. To reduce shrinkage of the pattern, we recommend using water-soluble stabilizer. ● Put together two layers of water-soluble stabilizer, otherwise the stabilizer material may tear during embroidering. 1 Outline of appliqué piece After embroidering is finished, remove the d stabilizer material from the embroidery frame. Use scissors to cut the excess water-soluble e stabilizer from outside the appliqué outline. Sew the placement line for the appliqué a position "APPLIQUE POSITION". 1 Pattern placement line Creating an Appliqué Piece 119